Acrylic case with 5V cooling fan for Raspberry Pi 4 - black - PiHut TPH-001

Product description: Case forRaspberry Pi 4B- Acrylic with 5V fan - Black - PiHut TPH-001

Fan case forRaspberry Pi 4. The case elements are made and laser cut out ofacrylic. The enclosure hasa 5-volt fanand numerous air vents to protect the minicomputer while maintaining adequate airflow. The product was manufactured in theUK. The fan should be connected to the GPIO Raspberry Pi 4 and 6 pins.

On our blogthere is a temperature test showing howRaspberry Pi 4Bcan be tampered with.

The kit includes the enclosure and the necessary mounting elements,Raspberry Pi 4Bmust be purchased separately.

Diagram of connecting the fan to pins 4 and 6 on GPIO Raspberry Pi.

Installation of the case

1. Remove the protective film from the housing components before installation.
2. Attach shorter distances to the lower black panel using 4 mm screws.
3. Place the Raspberry Pi so that the ends of the distances go through the mounting holes in the minicomputer board.
4. Screw the longer distances to the already installed ends.
5. Insert the side elements into the prepared cut-outs in the lower panel.
6. Screw the fan to the transparent panel of the enclosure, and position the fan with the PiHut sticker towards the minicomputer.
7. Connect the fan to pins 4 and 6 on the GPIO and put the top part of the case on so that it will fit into the side elements' grooves.
8. Tighten the top part of the case with screws for longer distances.

Tighten the screws carefully to avoid damaging the acrylic.

The kit includes

• Housing elements made of acrylic
• Fan 5 V
• Necessary assembly elements

Housing specifications

• Material: Acrylic
• Colour: Black and transparent top panel
• Fan: 5 V, 2 pin, 30 x 30 x 8 mm

Main components of the housing.

Useful links

• Manufacturer's website
• Installation instructions
• How to control the temperature of Raspberry Pi 4B